![]() Citrix Virtual Apps and Desktops Support.Operating Systems Requirements for Mobile Devices.Adding new software after setting up command strings can change how the computer's ports are used, which can affect command strings.Ī complete list of command strings is available at /command-strings/IntelliMixRoom.Requirements for end users to host and access meetings. For best results, install all software on the computer before choosing a port for command strings.Try a different port number and send the command until you receive a response.If you don't receive a response, the port is being used by another program.Make sure you are targeting IntelliMix Room's control IP address. Make sure that the port isn't being used by any other programs installed on the computer. Enter an available port to send and receive the command strings.In Designer, open the installation of IntelliMix Room you want to control and go to Settings > Command strings.You must choose an open port on the computer running IntelliMix Room to send and receive command strings. To control IntelliMix Room with third-party control systems, turn on command strings in Designer. Using Command Strings with IntelliMix Room IntelliMix Room Version 4.0 and Newer Inbound or outbound?Ĭ:\Program Files\Shure\IntelliMixRoom\dal\exe\conmon_server.exeĬ:\Program Files\Shure\IntelliMixRoom\Shure_IntelliMix_Room.exeĬ:\Program Files\Shure\IntelliMixRoom\dal\exe\apec3.exeĬ:\Program Files\Shure\IntelliMixRoom\dal\exe\ptp.exeĬ:\Program Files (x86)\Audinate\Shared Files\mDNSResponder.exe If there's a conflict with the default port, IntelliMix Room automatically selects a port from the specified range. /licmac=: NIC MAC address (without -) to use for licensing identification./licid=: NIC UUID to use for licensing identification./licipaddress=: NIC IP address to use for licensing identification./licindex=: NIC index to use for licensing identification./nicid_audio=: NIC UUID to use for Dante audio network capabilities./nicid_control=: NIC UUID to use for Shure control network capabilities./nicid=: NIC UUID to use for all IntelliMix Room network capabilities./nicipaddress_audio=: NIC IP address to use for Dante audio network capabilities./nicipaddress_control=: NIC IP address to use for Shure control network capabilities. ![]() ![]() /nicipaddress=: NIC IP address to use for all IntelliMix Room network capabilities./nicindex_audio=: NIC index to use for Dante audio network capabilities./nicindex_control=: NIC index to use for Shure control network capabilities./nicindex=: NIC index to use for both Shure control and Dante audio network capabilities./express: Installer runs with only a progress bar UI and keeps all previous settings.If there is an existing version installed, the installer uses the existing settings unless parameters listed below are provided. Installer runs without GUI and implements default options. Required for initial license activation.6 threads (logical processors) or better.Refer to Supported Hardware Systems for help choosing a device to run IntelliMix Room. Performance may vary on unsupported systems even if they meet all of these system requirements.Do not run IntelliMix Room and Designer on the same PC. ![]()
0 Comments
Leave a Reply. |